12.6V - 16-8V Electronic Inverter with remote control - RCX

The inverter will have two connection systems, one input, where the battery will be connected through an internal XT90 female connector.
And another output, where the motor to be used will be connected via an internal XT90 male connector. Both connectors are identified on the housing. Connecting the connections the wrong way round causes a short-circuit and causes it to break and stop working.

Up to 99 remotes can be synchronised at the same time on the same inverter. To synchronise a new control or re-synchronise the same one:

1st Press once on the status button, located on the housing, next to the on/off button (it includes a coloured LED).

2º When the LED on the status button lights up, you must press any button on the remote control.

3º The LED on the status button will flash 3 times indicating connection established.

You can clear the memory by pressing the status button for 10 seconds and then you can re-synchronise as many remotes as you wish.

The remote control has three control buttons:

STOP button: Stops the motor whatever the direction of travel and speed of the motor.

Power increase button +: Increases the power progressively forward from 0 to 100%.

Power decrease button -: Progressive power decrease backwards from 0 to 50%.  For safety reasons, the reverse power is limited to 50%.

COMPATIBLE AND TESTED WITH MOTORS OF:

-Float Plus versión 1

-Minnkota Endura 30lb

-Minnkota endura 40lb