copy of 12.6V - 16-8V Electronic Inverter with remote control

The inverter will have two connection systems, input, in which the battery will be connected through an internal XT90 female connector, compatible with our battery models. And output, which will be connected to the motor you want to use to proceed to its control through an internal male XT90 connector. Both are identified on the housing.

It also has an optional and additional man overboard connection system. It works by connecting it directly to the jack output, when the button is in position (o). In case of emergency it will automatically disconnect in case of an outboard fall. This system includes a safety lanyard.

The remote control can be re-synchronized by pressing once on the hole marked on the housing (when the red light comes on), press the power button on the remote control for 3 seconds (it will blink 3 times and beep to indicate a successful linkage). More than 1 controller can be synchronized at the same time on the same drive.

The remote control has three control buttons:

STOP button: Stops the motor whatever the direction of travel and speed of the motor.

Power increase button +: Increases the power progressively forward from 0 to 100%.

Power decrease button -: Progressive power decrease backwards from 0 to 50%.  For safety reasons, the reverse power is limited to 50%.

COMPATIBLE AND TESTED WITH MOTORS OF:

-Float Plus versión 1

-Minnkota Endura 30lb

-Minnkota endura 40lb